Home / Services / Sensor repair
Safety sensors and photo eyes
Garage Door Sensor Repair in Billings, MT
The safety sensors are the pair of photo eyes near the floor that stop the door from closing on a person, pet or object. When they are dirty, blocked or out of line, the door will not close. Call (406) 998-1481 if the checks below do not fix it.

What Garage Door Safety Sensors Do
Residential openers made on or after January 1, 1993 must have entrapment protection, usually a photo-eye pair (CPSC). One sensor sends an infrared beam and the other receives it. If something breaks the beam, the opener refuses to close the door or reverses it. A working safety system is not optional, so a sensor problem should not be ignored.
Signs of a Sensor Problem
| Symptom | Likely cause |
|---|---|
| Light off on one sensor | No power, loose or cut wire |
| Light blinking or dim | Sensor out of line or dirty lens |
| Works at night but not in the morning or afternoon | Direct sunlight on a lens |
| Door closes then goes back up | Beam interrupted, or travel limits set wrong |
| Opener blinks and will not close | Sensor fault, wiring or a failed sensor |
This is a guide only. A technician confirms the cause. If the sensors look fine but the opener itself is acting up, see garage door opener repair or garage door reverses after closing.
Checks You Can Do Safely
- Clear anything in front of both sensors
- Gently wipe each lens with a soft, dry cloth
- Check that both indicator lights are lit and steady
- Look for sunlight shining directly on a lens
- Look at the wires and brackets without touching or bending them
Do not bend the brackets, cut or splice wires, or remove the sensors. If the lights stay off or keep blinking, the wire looks damaged, or the door still reverses, call.
Never Bypass the Safety Sensors
Never disable or bypass the sensors or the auto-reverse, even if the door will not close. They protect people and pets under the door. If you are unsure the safety reverse still works, stop using the opener and call.
When to Call a Technician
- A sensor light stays off after you have checked what you can see
- The wire is damaged or buried in the wall
- The door still reverses with both lights steady
- You are unsure whether the safety reverse still works
What Professional Sensor Repair Involves
- Inspecting both sensors, the brackets and the wiring
- Finding the cause of the problem
- Repairing or replacing a faulty sensor or connection where needed
- Testing that the door closes and that the safety reverse works
If the opener itself needs replacing, see garage door opener installation.
What Affects the Cost of Sensor Repair?
The price depends on whether the cause is alignment, wiring or a failed sensor, how much wiring is involved, and whether the opener also needs work. Ask for the price when you call.
What Happens When You Call
- You describe what the door and the sensor lights are doing.
- We ask a few questions, such as whether the door will close at all.
- We confirm availability for your address in Billings on the call.
- A technician inspects the sensors and explains what is needed.
Garage Door Sensor Repair FAQs
Why will my garage door not close and the light is blinking?
Blinking opener lights often point to a sensor problem. Check for blockage, dirt and sunlight on a lens.
Can sunlight stop my garage door from closing?
Yes. Direct sun on a sensor lens can confuse the beam.
Is it safe to bypass the sensors?
No. Entrapment protection protects people and pets. Never bypass or disable it.
Why does my garage door close and then go back up?
The beam may be interrupted, or the travel limits may be set wrong. A technician can tell which.
When is a sensor problem actually an opener problem?
If both sensor lights are steady and the door still reverses or will not close, the cause may be the opener or the limits. See opener repair.
Call (406) 998-1481 or use the contact page.