Call (406) 998-1481

Home / Problems / Opener humming

Troubleshooting

Garage Door Opener Humming but Not Moving

When the motor runs but the door does not move, the problem is usually a broken spring, a door disconnected from the opener, or worn gears. Check the release cord below. If the door is heavy, stop and call (406) 998-1481.

What to check

  1. Look at the release cord. If the red cord was pulled, the trolley is disconnected. With the door fully closed, push the cord back and run the opener.
  2. Look for a gap in the spring above the door, without touching it.
  3. Try lifting the door by hand only with the opener disconnected and the door fully closed. If it is very heavy, stop.
  4. Listen to the motor. A grinding or whirring sound with no chain or belt movement can mean a stripped gear.

Likely causes

What happensLikely cause
Hums, door will not lift, bang earlierBroken spring
Motor runs, trolley does not travelDoor disconnected by the release cord
Grinding noise, rail does not moveStripped drive gear
Chain or belt slack or jumpedDrive problem
Clicks but no motionPower or logic board fault

Do not keep running the opener against a heavy door. It can damage the opener and the door.

Common questions

Why does my opener hum but the door does not open?

The most common reason is a broken spring. Others are a disconnected trolley or a stripped gear.

Can I run the opener with a broken spring?

No. It can damage the opener and the door.

Do I need a new opener?

Not always. Check the springs and balance first.

Related guides

Spring replacement

Most common cause.

Read more →

Opener repair

Gears and drive.

Read more →

Emergency repair

Door stuck.

Read more →

Not sure what is wrong with your door?

Call and describe what it is doing. You get a straight answer on the next step before any work starts.