Call (406) 998-1481

Home / Problems / Won’t close

Troubleshooting

Garage Door Won’t Close: Causes and Fixes

A garage door that will not close is most often a blocked or misaligned safety sensor. Wipe the lenses, check the lights, and see below. For springs, cables or tracks, call (406) 998-1481.

Check the safety sensors first

Residential openers made on or after January 1, 1993 must have entrapment protection, usually a pair of photo-eye sensors near the floor. If either one is blocked, dirty or knocked out of line, the door will not close.

  1. Clear anything in front of both sensors.
  2. Wipe each lens with a soft cloth.
  3. Check that both indicator lights are lit and steady.
  4. Gently re-aim a sensor until its light steadies.
  5. Try closing the door again.

Other causes

  • Sunlight shining into a sensor lens
  • Damaged or loose sensor wiring
  • Travel limits set incorrectly
  • Door off track or out of balance
  • Remote or wall-control fault

Common questions

Why does my garage door blink and not close?

Blinking opener lights usually mean a sensor problem. Check alignment and clean the lenses.

Can I close it manually?

Yes, with the release pulled, but only if the door moves freely.

Related guides

Reverses after closing

Similar cause.

Read more →

Opener repair

Motor or logic board.

Read more →

Emergency repair

Door stuck open.

Read more →

Not sure what is wrong with your door?

Call and describe what it is doing. You get a straight answer on the next step before any work starts.