Call (406) 998-1481
Home / Problems / Opener humming
Troubleshooting
Garage Door Opener Humming but Not Moving
When the motor runs but the door does not move, the problem is usually a broken spring, a door disconnected from the opener, or worn gears. Check the release cord below. If the door is heavy, stop and call (406) 998-1481.
What to check
- Look at the release cord. If the red cord was pulled, the trolley is disconnected. With the door fully closed, push the cord back and run the opener.
- Look for a gap in the spring above the door, without touching it.
- Try lifting the door by hand only with the opener disconnected and the door fully closed. If it is very heavy, stop.
- Listen to the motor. A grinding or whirring sound with no chain or belt movement can mean a stripped gear.
Likely causes
| What happens | Likely cause |
|---|---|
| Hums, door will not lift, bang earlier | Broken spring |
| Motor runs, trolley does not travel | Door disconnected by the release cord |
| Grinding noise, rail does not move | Stripped drive gear |
| Chain or belt slack or jumped | Drive problem |
| Clicks but no motion | Power or logic board fault |
Do not keep running the opener against a heavy door. It can damage the opener and the door.
Common questions
Why does my opener hum but the door does not open?
The most common reason is a broken spring. Others are a disconnected trolley or a stripped gear.
Can I run the opener with a broken spring?
No. It can damage the opener and the door.
Do I need a new opener?
Not always. Check the springs and balance first.
Related guides
Not sure what is wrong with your door?
Call and describe what it is doing. You get a straight answer on the next step before any work starts.